The day after Christmas, Mollie looked at me and said, "So do you want to make the bench today?" We had just barely finished the locker system for the laundry room, so I was not really expecting this. Having slated most of my vacation for
In our bedroom, there is a little bump out for a window, and we decided to make the bench fill that space. We debated the size quite a bit. Should it be only as deep as the window? We opted for a much deeper bench (Mollie wanted plenty of space for lots of pillows), and took the width of the foam as our guide. Should it go from wall to wall, or be narrower? We decided we wanted the curtains to be able to hang on either side of the bench, so we made it narrower than the space, just the same width as the window frame. First off, I built the basic skeleton of the bench from left over 2x4 and 2x6. It could have easily been built from just 2X4's but we didn't have enough, so we used the 2X6's (left over from our table we built last year) that were too warped for any other project. Since it was pretty wide, we actually built 2 benches to make sure it would have enough support in the middle.
As an aside, I really hate dealing with stud-wood. It is just so warped and difficult to use. But we still got it done. This was an ideal project for warped boards, since the skirt of the bench was going to hide everything from view. We used Kreg-Jig pocket-holing wherever we could, both building the frame and also for the eventual attachment of the seat to the frame. We had to drill this ahead of time, since the bench was going to be upholstered, it needed to be attached from beneath.
Mollie glued the foam down onto the plywood and then covered that in some additional batting to smooth the corners and edges.
Then we used the silk (after pre-treating it with scotchgaurd) to cover that.
The next step was the skirt. Mollie had purchased some home dec fabric to make the skirt, but it wasn't quite right. Then she remembered reading about people using canvas drop cloths for upholstery and such, and so while I was at Lowes, she called and had me pick up a drop cloth. Just $10 got us a 9ftX6ft drop cloth. Then she bleached it, and washed it (with lots of fabric softener and dryer sheets), and then ironed it with pleats.
The really great thing about a drop cloth is that it comes pre-hemmed. And a simple slit in the fabric allows you to rip it all the way down completely straight. No need for meticulous cutting or sewing. And it was just the look she was going for, and super cheap. So then, after Mollie pinned in the pleats, I attached it to the base of the bench with staples.The kreg-jig and the air compressor are our 2 most valuable tools. Such time savers.
The final bit was to attach the seat to the bench skeleton. We were pretty cautious here, because we didn't want to twist and distort the seat fabric. Using Kreg-Jig screws, we first secured the middle of the bench, where there was no fabric, and then tested a few screws on the back where it would not be as visible if something went wrong. As luck would have it, we were able to screw right through the fabric without it twisting. So we went ahead and put in all our screws and we were done.
The finished bench:
The kids love all the space underneath.
I have plans to build some storage compartments to go underneath, and serve as a charging hub for all our various electronics, which used to find themselves in a heap right here. And there's plenty of space to stash any other clutter that seems to find its way into our room. Kids included :)